Linksys WPS54GU2 Driver
Buy Cisco-Linksys WPS54GU2 Wireless-G Print Server for USB Cisco-Linksys WPS54GU2 Wireless-G Print Server for USB discontinued by. Wireless-G PrintServer for USB SKU WPS54GU2 User Guide PDF · Downloads / Firmware · Register Product. Wireless-G PrintServer for USB Linksys WPS54G v1, Marvell, Marvell, Marvell. Linksys WPS54G v2, Marvell, Marvell, Marvell. Linksys WPS54GU2, Brecis, Intersil, Intersil.
|Supported systems:||Windows 10, Windows 8.1, Windows 7|
|Price:||Free* [*Free Registration Required]|
Linksys WPS54GU2 Driver
The setup guide gave good directions on how to plug in all of the hardware. But when it came time for the setup wizard to autodetect the Linksys WPS54GU2, the wizard's device detection window came up empty.
We installed the Linksys management utility in hopes that it would detect the device, but no dice. After unsuccessfully attempting a hard reset, based on the user manual's instructions, we placed our first call to tech support--only to learn that the true hard reset process differed from what the Linksys WPS54GU2 described.
We finally achieved a hard reset, which resurrected the WLAN light, though multiple computers still failed to recognize the device. The tech-support rep told us that we needed to set a static Linksys WPS54GU2 address for our PC in the same subnet as the print server.
But because the rep couldn't supply us with the print server's IP, Linksys WPS54GU2 device documentation didn't list one, and we couldn't access the device settings to learn what it was, we were out of luck. When router is powered on, press the Linksys WPS54GU2 button and hold for 30 seconds.
Use a paper clip or something sharp While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds While still holding the reset button down, turn on the power to the unit again and Linksys WPS54GU2 for another 30 seconds. This process usually works for resetting any router to it's factory setting. I do not recommend Linksys WPS54GU2 the Web interface to set it up, ubder firmwarethe Web interface is problematic.
I have Linksys WPS54GU2 used the setup wizard or the Biadmin Management Utility to set up the printserver. If you successfull connected your printserver run the Biadmin Management Utility.
It will scan for the printserver. If it does not sacn again.
Type in the default password "admin" in lowercase. I suggest you change it. This will get you to the configure menu.